tyler_leon
Civil/Environmental
Hi all,
I have a question about the initialization of stresses in FLAC3D v5.00.
I have a complex model with an irregular topography. I set the gravity with the command
set gravity 0 0 -10
but how can I initialize correctly the stresses? Till now I simply indicate a gradient in each direction starting from the surface, but in this case is not constant.
Somebody can give me an help?
Thank you!
I have a question about the initialization of stresses in FLAC3D v5.00.
I have a complex model with an irregular topography. I set the gravity with the command
set gravity 0 0 -10
but how can I initialize correctly the stresses? Till now I simply indicate a gradient in each direction starting from the surface, but in this case is not constant.
Somebody can give me an help?
Thank you!