Filter a component varied in a family table from 2D Repeat Region

[McCormickN]

Hello,

I have a 2D repeat region that is reporting all of the parameters from my assembly level family table. The assembly family table also has a column that varies a component in each assembly instance. I would like to filter this varied component column from the repeat region on the drawing.

Does anyone know how to do this? I have attached a couple images below showing the situation.

Thanks for the help!

- Nat

 

[per2fh]

If I understand this correctly, can you not just remove the column from the drawing table?

 

[dross]

No, you cannot as it is coming from the family table.