Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fill pattern in Soliedge
- Thread starter Kitshwa
- Start date
Yes, at least I was using them last week on V19.
I can't recall the details but there are settings to change up on the ribbon bar I think.
I can't recall the details but there are settings to change up on the ribbon bar I think.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
SolidMastermind
Computer
Yes Fill pattern is available.
When you define the pattern sketch, change the Fit option in the Command bar to Fill. You will then be able to define the pattern occurrence spacing for both X and Y.
Jon Sutcliffe / Solid Mastermind
The Solid Edge Community. Video training sessions, best practice documents, process maps and interactive training
When you define the pattern sketch, change the Fit option in the Command bar to Fill. You will then be able to define the pattern occurrence spacing for both X and Y.
Jon Sutcliffe / Solid Mastermind
The Solid Edge Community. Video training sessions, best practice documents, process maps and interactive training
- Status
Similar threads