FIle load error

[Alderfek]

Good morning,
Having a slight issue of not being to open any parts. I get one of two messages...

"An attempt was made to set a constrained attribute to a value outside its limits"
or
"Internal memory access violation"

The only thing that changed was some of my load options concerning lightweight representations. The NX help desk folks are working this, but I was wondering if anyone else had ran into this and what their fix might have been.

Thanks,
Kirk

Kirk Alderfer
Designer
Meggitt Polymers & Composites
Rockmart, Georgia

"Imagination continually frustrates tradition, that is its function." -John Pfeiffer

 

[Alderfek]

Fixed the issue...just dont know why it did whatever it did. Ended up going into my AppData and deleting out my "user", "NX85_user" and my drafting standard mtx files and letting the system reset itself.

Kirk Alderfer
Designer
Meggitt Polymers & Composites
Rockmart, Georgia

"Imagination continually frustrates tradition, that is its function." -John Pfeiffer

 

[JohnRBaker]

Yes, that was an issue and you should be OK now.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Alderfek]

just as an FYI...IR 6982769 has been converted to PR 6982769... this is what started the whole mess that this turned into

Kirk Alderfer
Designer
Meggitt Polymers & Composites
Rockmart, Georgia

"Imagination continually frustrates tradition, that is its function." -John Pfeiffer