Does somebody have problems cutting ss201LN. Me not stable at all. And have to film burning before. I tried low speed like 75in/minute as like 235in/minute. I tried gas from 15 bar to 20 bar. I tried focal like -3.9 to -5.6 and Stil Nevers good. That for 1/4. Got à bit less problems with 7 ga.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fiberlaser 6kw and ss201LN
- Thread starter Ermak
- Start date
Similar threads
- Question
- Locked
- Question