Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

few doubts

  • Thread starter Thread starter provdevi
  • Start date Start date
Status
Not open for further replies.
P

provdevi

Guest
Hi all !


I would like to clarify few doubts in inventor


1. how to get thedevelopment of surfacefor a soild part?


2. is bending table insertion in detailing mode for a sheet metal part?


3. sheet metal from solid part


4. sheet metal to soild part


5. 2D development of sheet metal part in DFX and is it possible to feed to CAM directly


6.is any special module or partner solution available for plant constrction design work
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top