Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

feroresonance resistor

Status
Not open for further replies.
vreijb

vreijb

Electrical
Nov 22, 2006
38
What would be the size of the ferro resonance resistor for PT 100VA, with 4200/69/69 V. The plant is 7.2KV with high resistance grounding
any assisstance is aprrecviated
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Thank you David.

Bill
--------------------
"Why not the best?"
Jimmy Carter
 
Upvote 0 Downvote
what about overvoltage factors 1.5 for 8H, 1.9 for 30min, and 1.2 cont. doesn't mean anything knowing we will trip in case of earth fault.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

N
  • Question
On ferroresonance damping resistor
Replies
3
Views
2K
wcaseyharman
wcaseyharman
JezNZ
  • Locked
  • Question
Modelling an Open Delta (with LV Resistor) Earthing Transformer in ETAP
Replies
2
Views
569
Kiribanda
Kiribanda
NickParker
  • Locked
  • Question
REF - In Zone Faults - Voltage across relay terminals with Stabilizing resistor 1
Replies
2
Views
237
RRaghunath
RRaghunath
DBL-E
  • Locked
  • Question
Are Neutral Ground Resistor for 100 MW + PV sites common and what are the pros/cons?
Replies
1
Views
179
wcaseyharman
wcaseyharman
mastergate
  • Locked
  • Question
Neutral grounding for Wind & Solar MV network (Reactor vs Resistor) 3
Replies
3
Views
427
wcaseyharman
wcaseyharman

Part and Inventory Search

Sponsor

Back
Top Bottom