Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

feature isolation

  • Thread starter Thread starter ice_man
  • Start date Start date
Status
Not open for further replies.
I

ice_man

Guest
Hi guys:

What does feature isolation do in AutoGEM settings? How can we use that?

Thank you.
 
you can refine mesh there. Also if its a surface or volume region you can discard the results over there it causes high stress concentrations.


Israr
 
Status
Not open for further replies.

Similar threads

T
Angle analysis feature to be used as a dimension in a drawing table
Replies
1
Views
14K
annad_m_s
A
nmarco
  • Locked
  • Question Question
Pattern tables and feature name creation
Replies
1
Views
282
mjcole
mjcole
Bauer1983
  • Locked
  • Question Question
Feature weld vs End weld in Pro mechanica
Replies
4
Views
253
Bauer1983
Bauer1983
M
Angle measure feature not going negative
Replies
3
Views
5K
M Woodhams
M
J
Analysis Feature - Distance (+/-)
Replies
7
Views
6K
jveliquette
J

Part and Inventory Search

Sponsor

Back
Top