Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Feature based machining - get CSYS of recognized feature

Thread starter kukelyk
Start date Jan 13, 2014

Status: Not open for further replies.

Jan 13, 2014

kukelyk

Industrial

When find features makes new machining features, they have their own csys. It is very good for 3+2 drilling, but.
For drilling, they need a MCS, where the Z direction is the same. If I could winkle the CSYS data out, I could make it automatically.. Is there a way to accomplish it?
thanks in advance

----
kukelyk