These are my Feature Attributes. Is there a way to access these under the Annotation Editor. I am creating a point chart for a CMM and would like to label the points (Roadmap). "MVEC_X_VALUE"=(real)"3824.5000000000000000" "MATERIAL OFFSET"=(reference)" " "MVEC_Y_VALUE"=(real)"-207.0936261967100000" "MVEC_Z_VALUE"=(real)"543.8524561739700000" "MVEC_I_VALUE"=(real)"0.0000000000000000" "MVEC_J_VALUE"=(real)"-0.9986295347545800" "MVEC_K_VALUE"=(real)"0.0523359562428100" "TYPE"=(string)"SURFACE_VECTOR" "DIRECTION"=(string)"Along Normal"

Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Feature Attribute as Annotation

Thread starter AdvantageDesign
Start date May 27, 2005

Status: Not open for further replies.

May 27, 2005

AdvantageDesign

Automotive

These are my Feature Attributes. Is there a way to access these under the Annotation Editor. I am creating a point chart for a CMM and would like to label the points (Roadmap).

"MVEC_X_VALUE"=(real)"3824.5000000000000000"
"MATERIAL OFFSET"=(reference)"<X10.3@p1>"
"MVEC_Y_VALUE"=(real)"-207.0936261967100000"
"MVEC_Z_VALUE"=(real)"543.8524561739700000"
"MVEC_I_VALUE"=(real)"0.0000000000000000"
"MVEC_J_VALUE"=(real)"-0.9986295347545800"
"MVEC_K_VALUE"=(real)"0.0523359562428100"
"TYPE"=(string)"SURFACE_VECTOR"
"DIRECTION"=(string)"Along Normal"