Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Feasibility

  • Thread starter Thread starter MFegenbush
  • Start date Start date
Status
Not open for further replies.
M

MFegenbush

Guest
Using WF2, I would like to adjust one of the offset dimensions of an
axis to make the distance between it and another axis equal some
value. Example: A1 is 200mm from DTM1 (offset reference) and
176mm from A2. What value of (offset reference) is required to
make the distance between A1 and A2 200mm?



Something like that. I remember learing this once, but I don't know where the information went off to.



Thanks.
 
As is my usual nature, I found the "add feature" button in the
Analysis>Measure dialog box (it was there the whole time, of
course), which allowed me to get the solution on my own. However,
if anyone has any insight into the process, I would still love to hear
it.



MFegenbush
 
<DIV>Using the Analysis feature is one way, but could you not represent this required geometry in a sketch? If so, you could use the vertex of the sketch to place A2.</DIV>
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top