FEA

[SolidCreative]

Can someone explain why this parts shows more displacement at the bottom then at the top. It reads that there is .00002 inch at the bottom, and .0002 inch of deformation at the top??? I must be reading this chart wrong.

Your file's link is:

http://files.engineering.com/getfile.aspx?folder=b6a10cdf-1e13-4b1c-8f55-695fb9f058e4&file=fea.JPG

 

[mcgyvr]

.00002 is less than .0002
It must be Friday...

Also please see your post about the open idw from part/assy files and let me know if that macro works

 

[SolidCreative]

Has anyone seen any examples online where they actually explains the results of the analyis?

 

[SolidCreative]

It is friday, and a longweekend! Apparently, something I've already started