PiyaliC
Mechanical
- Feb 17, 2004
- 1
I only have access to Ansys Version 5.7.. I am trying to find a way to apply a time varying force, but I am not sure how to do it. The force is essentially a step input that last for a duration of 1 second. Any ideas of how to input that?
This is occuring on a flat plate(dimensions in the X-Y direction) while the force is applied to the center of the plate in the z direction.
This is occuring on a flat plate(dimensions in the X-Y direction) while the force is applied to the center of the plate in the z direction.