Can anyone recommend an FAT procedure for a 400V electrical 3 phase panel common on industrial machinery. We are developing an internal pre-FAT document and my electrical knowledge is limited so I’m not sure what specifics need checking apart from tidiness and labelling.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
FATing Electrical Panels for industrial machines
- Thread starter Finglas
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question