Fatigue Properties for Nitronic 50 (UNS S 20910)

[dcopps]

This material is highly corrosion resistant, which is why I am posting this question here.

I am looking for fatigue properties for Nitronic 50, particularly as they relate to Endurance Limit, Fatigue Strength, Number of cycles N versus Strength Sa. Specifically, we care about very high cycle fatigue, where N is greater than 1e8 cycle life.

Thanks for any help.

 

[EdStainless]

For which condition, as cold worked to higher strength or the annealed condition?
The only data that I have is for cold worked material.

A quick internet search comes up with:
Rotating beam fatigue, 10e8 cycles for 1" bar
annealed 47ksi (this should be 55-60ksi yield, 110-120ksi UTS)
HS (as hot rolled) 68ksi

This stuff has been used for prop shafts in boats for decades so there should be a lot of fatigue data out there.


= = = = = = = = = = = = = = = = = = = =
Plymouth Tube

 

[mrfailure]

Check out the attached link, Table 17, as a starting point. It give fatigue at 10⁸ cycles.

http://www.hpalloy.com/alloys/brochures/Nitronic50book.pdf

Aaron Tanzer

http://www.lehightesting.com

 

[tomwalz]

Try the folks at HP Alloys


Thomas J. Walz
Carbide Processors, Inc.

http://www.carbideprocessors.com

Good engineering starts with a Grainger Catalog.

 

[skailup]

Searching DTIC gave this result. The document was scanned and thus lost some clarity.

[URL unfurl="true"]http://oai.dtic.mil/oai/oai?verb=getRecord&metadataPrefix=html&identifier=ADA020974[/url]