Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fatigue 1 and Fatigue 2

Status
Not open for further replies.
bridgeengineer2007

bridgeengineer2007

Civil/Environmental
Joined
May 2, 2012
Messages
27
Location
US
If a Fatigue element passes Fatigue 1 but not Fatigue 2, is it OK? It seems possible for this to happen just based on the formula for Fatigue 2 with the ADTT, but by definition it seems that if the CAFT is reached and Fatigue 1 passes, Fatigue 2 doesn't matter.

Thoughts?
 
Status
Not open for further replies.

Similar threads

R
  • Question Question
Question regarding fatigue in AS/NZS 1664.1
Replies
1
Views
7K
TomLee777
TomLee777
mecheng24
  • Question Question
Fatigue stress category for weld shear flow
Replies
1
Views
9K
TomLee777
TomLee777
sam3990
  • Locked
  • Question Question
Fatigue hot spot stress using FEA - general discussion
Replies
0
Views
2K
sam3990
sam3990
Hunter90
  • Question Question
Steel-to-Steel Fastening with total thickness greater than 1/2"
Replies
11
Views
11K
ErikBjurSE
E
Karunanayake
  • Question Question
Notch and bore at middle 1/3
Replies
2
Views
6K
Karunanayake
Karunanayake

Part and Inventory Search

Sponsor

Back
Top