Fasteners Length

[Bester2]

I searched the past threads and could not find an answer to this question even though I am sure that it has been asked before. I have inserted fasteners into my assembly and accidentally made them the wrong length (I inserted them from the toolbox). Can I modify the length inside the assembly without opening the parts or replacing the fasteners that I already have in the assembly.

 

[ctopher]

If there are configurations in the part, you can right click on the part in the feature manager, change config. Otherwise, replace the part.

Chris
SolidWorks 07 2.2/PDMWorks 07
AutoCAD 06
ctopher's home (updated 02-10-07)