Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fanuc RJ 2's M410i 's- Looking for options to replace or keep going

Status
Not open for further replies.

CyDog

Electrical
Aug 8, 2007
12
US
Thanks for reading this post.
We have 4 Fanuc RJ 2's M 410i's. As you know getting parts for these are slowing getting difficult. I would like
to get some advice on some options .We are on a very limited budget .I was thinking of doing the following.

1. Buy a used RJ 2 and use for spare parts.
2. Replace the RJ 2's with a RJ 3.
( How difficult would it be to duplicate the program in
a RJ 2 to a RJ 3 ?)
Please feel free to reply with other options.
 
Replies continue below

Recommended for you

CyDog, usually finding a spare robot for parts is not a bad way to go. Electrical parts are fairly easy to find for RJ2 although the 4 axis amp will be a little tougher. Mechanically gear reducers are expensive to replace as are motors although the motors can be repaired unlike the reducers. If you know RJ2 programming you can easily get up to speed on RJ3.

Glenn
 
 http://www.icrrobotsolutions.com
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top