family table

[jlesniak]

How to you override a dimension on a family table with a dash?

 

[dross]

In the family table or in a drawing?


If in drawing, go to the dimension properties and replace the "d" with an "o", then place your dash.

 

[rahul.d19881]

For Overiding the dimension in family table


Just Go to Properties of dimension there you can see @d make there change as


@o and put your dimension value in front of o OK

 

[dross]

For Overiding the dimension in family table


Just Go to Properties of dimension there you can see @d make there change as


@o and put your dimension value in front of o OK

It should be behind the "o", not in front.


@o -
Edited by: dross

 

[jlesniak]

I understand what you are all saying above but the dimension in the family table is referncing a datum and I dont know where I can add the @o to override.

When you add a datum you have to offset if off an edge or surface differently than you do when you extrude or anything else. Datums have their own menu.