Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fairly new to Inventor

Status
Not open for further replies.

tongy66086

Mechanical
Nov 29, 2006
8
US
I'm fairly new to inventor and not really sure how to proceed on laying this part out.
I'm not sure how to put the 45 degree corners on each end.
I've attached a pdf of what I'm struggling with.
I really appreciate everyone's help.

 
Replies continue below

Recommended for you

Inventor version?
use the "cut across bend" option with the cut tool
 
Attach your ipt file here of what you have been able to complete if you can't figure it out.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor