Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Failure Index Plot Hypermesh

Status
Not open for further replies.
flyforever85

flyforever85

New member
Joined
Jun 22, 2010
Messages
178
Location
US
I need to plot the Failure Index of a composite laminate in HYpermesh. I set the paramters NOCOMP to 1. the solution runs smoothly but there is no trace of failure index whatsoever.

I know of the existence of this post but I can't still figure it out
 
Status
Not open for further replies.

Similar threads

Gardenfence
  • Locked
  • Question Question
CBUSH coincident nodes in hypermesh?
Replies
1
Views
2K
SWComposites
SWComposites
mohamed hassan 2014
  • Locked
  • Question Question
Nonlinear analysis using HyperMesh with OptiStruct
Replies
0
Views
620
mohamed hassan 2014
mohamed hassan 2014
NASAJPL
  • Locked
  • Question Question
Print Some / Plot Others Playing Nicely
Replies
1
Views
194
rb1957
rb1957
compe_ad
  • Locked
  • Question Question
Stress vs logarithmic strain plot from Abaqus
Replies
6
Views
1K
swimfar
swimfar
compe_ad
  • Locked
  • Question Question
Concrete failure point in Abaqus
Replies
4
Views
776
compe_ad
compe_ad

Part and Inventory Search

Sponsor

Back
Top