Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

F6NM Hardness Acceptance Criteria

Status
Not open for further replies.
WeldGk

WeldGk

Materials
Aug 14, 2007
42
Does nayone know where I can find hardness acceptance for F6NM for NACE MR0175 in terms of HV10 (Table A.18 of ISO 15156 only provides acceptance in terms of Hrc (23)) and the conversion factors in ASTM do not apply to martensitics.
 
Status
Not open for further replies.

Similar threads

Shivasankar2593
  • Locked
  • Question
ASTM AG48 Method A - Acceptance criteria 1
Replies
9
Views
708
EdStainless
EdStainless
montbIanc
  • Locked
  • Question
Marine sacrificial anodes - Clarification of design criteria
Replies
4
Views
702
FacEngrPE
FacEngrPE
Corroneer
  • Locked
  • Question
SSC for Piping with Unknown Hardness Levels? 1
Replies
3
Views
222
SJones
SJones
SiggiN
  • Locked
  • Question
Hardness test location 1
Replies
1
Views
226
jmec87
jmec87
hsemus
  • Locked
  • Question
Intergranular corrosion acceptance criteria clarification 1
Replies
4
Views
315
SJones
SJones

Part and Inventory Search

Sponsor

Back
Top Bottom