Majid_F93
Geotechnical
- Feb 2, 2018
- 27
Hi
i want to extract two-dimensional profiles and remeshing using abaqus. i found out its necessary to use command line such as PartFromOdb, but i don't know how to use this command in my own model. can everyone help me in this problem with an example?
in following pictures there are some explanation about this technique, but i don't understand them.
i want to extract two-dimensional profiles and remeshing using abaqus. i found out its necessary to use command line such as PartFromOdb, but i don't know how to use this command in my own model. can everyone help me in this problem with an example?
in following pictures there are some explanation about this technique, but i don't understand them.
