Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Extracting strain tensor in a DLOAD user subroutine

Status
Not open for further replies.
BenOB

BenOB

Bioengineer
Joined
Jun 18, 2007
Messages
1
Location
NZ
Hi All,

I am running an ABAQUS 6.7 simulation involving electrostatics where the pressure over a surface depends on the strain state of the material under the surface.

I am defining the pressure in a DLOAD user subroutine and I would like to use GETVRM or similar to find the strain state.

However it appears that GETVRM is not supported within the DLOAD user subroutine.

Does anyone have any suggestions on how to do this?

Cheers,

Ben
 
Status
Not open for further replies.

Similar threads

I
  • Locked
  • Question Question
Abaqus subroutine
Replies
3
Views
3K
FEA way
FEA way
I
Abaqus Subroutine
Replies
4
Views
6K
FEA way
FEA way
M
  • Locked
  • Question Question
Assistance with VUHARD Subroutine in Abaqus
Replies
3
Views
3K
FEA way
FEA way
jball1
  • Locked
  • Question Question
Extracting nodal forces
Replies
1
Views
1K
jball1
jball1
Balamugesh M
  • Locked
  • Question Question
Abaqus user subroutine problem
Replies
12
Views
2K
IceBreakerSours
IceBreakerSours

Part and Inventory Search

Sponsor

Back
Top