Extract Geometry - Trim Body Error

[BrittToolEngineer]

Greetings:

Attached is a PowerPoint pic to help see the issue. I've extracted geometry from a part, then extend the edges to make a larger trim body. Looking at the pic, you can see where two edges did not stay together in the extend. Can anyone advise how this can be fixed, or maybe I did not extend properly?

Thanks in advance,

Brent

 

[BrittToolEngineer]

forgot to attach, here is the pic

 

[Rob_N]

lots of ways, depending on your needs.
if its an out of part fix, one method I use is a 2nd, negative extension to make the gap bigger. bridge curve the outer edge and fill surface to fill it in.

 

[ranjithbelur]

You can also try by selecting the highlighted edge while extending the sheet.

Ranjith P R
Automotive Seatings

 

[Toost]

can you export , only these sheets using parasolid and upload ?
( File- export- parasolid, then select the sheets to export - OK -...)
these sheets should not contain any secret data i hope.

- There are quite a few options to heal this crack in NX.


Regards,
Tomas

 

[BrittToolEngineer]

Tomas,

I have resolved this issue, but just posted another challenge that I'm having difficulty with regarding a groove in this contour. Could you possibly help with that? I have attached models.

Thanks,

Brent