Extension Lines

[mncad]

I know how to slant the extension lines in a drawing but that makes the extension lines parallel, is there any way to make the extension lines slant toward each other in SW2003? I'm dimensioning the gauge diameter of a tapered shaft and it would look better if the extension lines slanted toward each other.

Thanks,
mncad

 

[TheTick]

One possible technique:
Download zip file from this page:

http://rschwarz.tripod.com/CAD/TaperedShaft.htm

This is a method for sketching lines on a view for use as extension lines. Note use of vertical and horizontal constraints on enpoints to keep sketched curves associative with model geometry.

Good and evil: wrap them up and disguise it as people.