Exporting Assembly sketches

[jdsmi]

I'd like to resurrect an old thread thread559-90953 to see if anyone has figured this out yet.

I have been unable to get assembly sketch entities to export into any type of neutral file. If you look at the IGES options there is a button for curves but they do not export.

 

[Theophilus]

Perhaps you can save your assembly as a part and then attempt the export?

Jeff Mowry

http://www.industrialdesignhaus.com

Reason trumps all. And awe trumps reason.

 

[jdsmi]

If I remember correctly, I tried that and the assembly curves would not file with the part - No go. I don't think I tried that in 2006 yet though, I'll give a try again.