Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
export assembly outside teamcenter
- Thread starter Forzindi
- Start date
In the UGManager folder, in your NX installation directory, you will find two bat files. ug_export.bat and ugmanager_clone.bat
Both you can use to export assemblies outside Teamcenter. These files can be executed without running NX.
Commandline parameters are explained in the batfiles themselves.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
Both you can use to export assemblies outside Teamcenter. These files can be executed without running NX.
Commandline parameters are explained in the batfiles themselves.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
- Status
Similar threads
- Locked
- Question
