Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Experience with reverse impact extrusion!!

Status
Not open for further replies.
Bryex

Bryex

Mechanical
Joined
Jun 24, 2001
Messages
23
Location
GB
Has anybody any experience with this manufacturing process? Is it a rapid cycle process? I'm asking because there's a job vacancy at a major aluminium gas cylinder manufacturer.


Any opinions would be helpful.


Regards


Bry
 
Sort by date Sort by votes
"Rapid" is a relative term so I am not sure how fast you are talking. The process cycle time will depend on the volume and strength of the material being formed. Just for a ball park, kycle times less than 10 seconds are done.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

rQuestionEngineering
  • Locked
  • Question Question
Did you regret buying M18 Milwaukee impact wrench?
Replies
6
Views
515
enginesrus
enginesrus
Justin Langley
  • Locked
  • Question Question
Laser Cutting Perforated Sheets - Problem with Warpage
Replies
2
Views
1K
ZixmiX
ZixmiX
Rahe
  • Locked
  • Question Question
Help needed with homemade wool shredder
Replies
0
Views
822
Rahe
Rahe
65CCJ
  • Locked
  • Question Question
Repair NPT Male Thread With Repairing Die
Replies
3
Views
817
BiPolarMoment
BiPolarMoment
Gerard-E
  • Locked
  • Question Question
machined PVC with groove = bending/warping problems
Replies
2
Views
575
John Donlan
John Donlan

Part and Inventory Search

Sponsor

Back
Top