I have the following ETABS model. I am having problems eliminating the load combinations that include wind load as a DOWNWARD load:
1.2D + 1.6L + 0.80W
1.2D + 1.6W + 0.50Lr
0.90D + 1.6W
I have tried Design/Steel Frame/Select Design Combos, but even though I remove the combos from the list when I run the model it still analyzes those combos.
A quick check of the model would also be greatly appreciated since I am new to using ETABS.
Thanks.
1.2D + 1.6L + 0.80W
1.2D + 1.6W + 0.50Lr
0.90D + 1.6W
I have tried Design/Steel Frame/Select Design Combos, but even though I remove the combos from the list when I run the model it still analyzes those combos.
A quick check of the model would also be greatly appreciated since I am new to using ETABS.
Thanks.