Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Error message

Status
Not open for further replies.
blckwtr

blckwtr

Mechanical
Joined
Oct 30, 2006
Messages
204
Location
NO
Using shell for meshing, loads and restraint applied, I get an error message:

No loads are applied to the model.

What is wrong?
 
Sort by date Sort by votes
Make sure that loads and restrainsts are applied to the same surface that you used to generate the shell.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

oharag11
  • Locked
  • Question Question
Error - Please enter a value greater than 0 - Thermal Joint?
Replies
0
Views
989
oharag11
oharag11
pllmoreau
  • Locked
  • Question Question
Solidworks Simulations Bearing Load error
Replies
4
Views
2K
pllmoreau
pllmoreau
IdanPV
  • Locked
  • Question Question
Error Message - SolidWorks Simulation
Replies
2
Views
1K
IdanPV
IdanPV
cbrf23
  • Locked
  • Question Question
How to interpret error message? "For plasticity models, raise: ETAN > Ex/100"
Replies
0
Views
707
cbrf23
cbrf23
PacoB
  • Locked
  • Question Question
Error Solidworks simulation
Replies
0
Views
167
PacoB
PacoB

Part and Inventory Search

Sponsor

Back
Top