Thank you ijr.
I remove the isolator, and I put simple supports and run the model, but I still receive the following message:
Unable to complete operation 'Run Analysis'!
Error 6
Overflow
but when I remove the 1997 UBC Isolated Seismic Load Pattern, and I put the 1997 UBC Seismic Load Pattern , and I put the isolator
and run the program, the error is lifted.
I appreciate your assistance in this matter.
I remove the isolator, and I put simple supports and run the model, but I still receive the following message:
Unable to complete operation 'Run Analysis'!
Error 6
Overflow
but when I remove the 1997 UBC Isolated Seismic Load Pattern, and I put the 1997 UBC Seismic Load Pattern , and I put the isolator
and run the program, the error is lifted.
I appreciate your assistance in this matter.