We have purchased a few robots that came from an old Saturn Plant. We have a servo fault that we can not clear. Documentation says that this fault is NTED?Servo Disconnet.
Is there a way to bypass or clear this fault? We have limited documentation and we can't find where this is connected and where to "jumper" it out. We are trying to move the axis' via the teach pendant but this fault is stopping us from doing so.
Any help would be most appreciated.
Thanks.
Is there a way to bypass or clear this fault? We have limited documentation and we can't find where this is connected and where to "jumper" it out. We are trying to move the axis' via the teach pendant but this fault is stopping us from doing so.
Any help would be most appreciated.
Thanks.