Error: An operation was attempted on an invalid or unsuitable OM object

[magnusrm]

I have encountered the error "An operation was attempted on an invalid or unsuitable OM object" two times lately, where nothing can be done (no saving, changing etc).
The error message just comes back as fast as I have pressed "OK".

The issue occurs on a simplified FEA model, when I have made changes to the original part and tries to open the FEM-file for updating the mesh.

Siemens NX 9

Anyone else seen this bug?

 

[JohnRBaker]

You probably should contact GTAC and let them look at the part file(s) for you.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.