Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Equipment with dimple jacket to Australia

Status
Not open for further replies.

KC Nga

Mechanical
Dec 16, 2019
1
Hi,

I am working on a 10m3 buffer bin which comes with 3pcs of screw conveyor. There is dimple jacket at the bottom of the bin that requires 0-0.2BarG dry saturated steam. This buffer bin will be delivered to Australia. May i know if such bin is considered as pressure vessel for AS1210?

KC
 
Replies continue below

Recommended for you

Is 0-0.2 barg the operating pressure range, what is the design pressure for the jacketed trough? Or what is the over pressure protection set to? This may or may not fall below the curve in AS1210 but it would be good practice to design it in accordance with the requirements of AS1210, in particular 3.23.8 covering Jacketed Troughs.
 
Is this not something you should have discussed with the Customer / Client before you started working on it ?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor