Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Equation Editor Volumes

Status
Not open for further replies.
drawoh

drawoh

Mechanical
Joined
Oct 1, 2002
Messages
8,991
Location
CA
I am trying to do some analysis within SolidWorks' equation editor. When I assign "SW-Volume" to a variable, I get the message "Potential circular reference", and it takes much fiddling around to make it update correctly. I am trying to convert a film wrapping into a length value for the BOM.

Is there a reliable way to call up volume within the equation editor?

--
JHG
 
Status
Not open for further replies.

Similar threads

N
Simple Hole sketch dimensions in Equation Manager
Replies
0
Views
1K
NirVid
N
NirVidP
  • Locked
  • Question Question
Simple Hole sketch dimensions in Equation Manager
Replies
4
Views
533
ctopher
ctopher
Sangramkr1992
  • Locked
  • Question Question
Equation of a spline from SOlidworks
Replies
4
Views
909
handleman
handleman
jdomechanical
  • Locked
  • Question Question
Trig equations in sketcher not evaluating properly
Replies
5
Views
724
jdomechanical
jdomechanical
sshhehab
  • Locked
  • Question Question
SWx 2019 with SmarTeam Editor V5-6R2018 modified components issue
Replies
1
Views
353
drawoh
drawoh

Part and Inventory Search

Sponsor

Back
Top