Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Equal length / dist constraint in sketcher
- Thread starter holyghost
- Start date
Hello holyghost,
There isn't a direct way to do this (like in SolidWorks, for example) but you can do the next best thing... create dimensions for both those lines (or more) and create an Equivalent Dimension
.
More about this can be found here_1 and here_2.
Hope this helps,
Best of luck!
CATIA V5R19 – user & trainer
ANSYS – beginner
There isn't a direct way to do this (like in SolidWorks, for example) but you can do the next best thing... create dimensions for both those lines (or more) and create an Equivalent Dimension
More about this can be found here_1 and here_2.
Hope this helps,
Best of luck!
CATIA V5R19 – user & trainer
ANSYS – beginner
- Status
Similar threads
- Locked
- Question