Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

EQ FORCE STARTING LEVEL

Status
Not open for further replies.
hsn199

hsn199

Civil/Environmental
Joined
Oct 18, 2012
Messages
28
Location
SA
Hey, I wanna ask at what level Shall EQ be inputted in ETABS? Starting from the base or starting from the ground floor? Cuz I've been told from the GF, and this frankly isn't convincing... Any help?
 
Sort by date Sort by votes
WannabeSe, Sencere thanks for your helpful comment :D
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Miladm2
  • Question Question
Truss Roof – Joint Force Imbalance Due to TRP Plate Modeling
Replies
4
Views
12K
Miladm2
Miladm2
S
  • Question Question
Large UZ force in one of the slabs
Replies
2
Views
2K
GJoeRMK
GJoeRMK
compe_ad
  • Locked
  • Question Question
Warrning message - "No usable starting vectors are available; no ritz modes can be found"
Replies
3
Views
2K
li0ngalahad
li0ngalahad
InnovatorX
  • Locked
  • Question Question
ETABS (22) API Section Cut Forces
Replies
3
Views
3K
sticksandtriangles
sticksandtriangles
InnovatorX
  • Locked
  • Question Question
ETABS API Pier and Spandrel Forces ETABSv1.dll ETABS 21 & 22
Replies
2
Views
2K
InnovatorX
InnovatorX

Part and Inventory Search

Sponsor

Back
Top