Bobbycartuner
Materials
- Apr 19, 2010
- 7
Hi,
I'm not used to work with Abaqus on electrical issues.
I try to put a current of 0.5A on a specimen. Current enters the top side of the specimen with 0.5A and leaves at the bottom side with -0.5A. Is this setting correct to simulate a current of 0.5A trough the specimen?
The next question is how to query the electric potential from two different points(I want to simulate the crack size in the specimen). Do I just query the EPG of those points and calculate the difference? Is it given in Volt then?
Greetz from Aachen Germany
Karl
I'm not used to work with Abaqus on electrical issues.
I try to put a current of 0.5A on a specimen. Current enters the top side of the specimen with 0.5A and leaves at the bottom side with -0.5A. Is this setting correct to simulate a current of 0.5A trough the specimen?
The next question is how to query the electric potential from two different points(I want to simulate the crack size in the specimen). Do I just query the EPG of those points and calculate the difference? Is it given in Volt then?
Greetz from Aachen Germany
Karl
