Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Engineering Stress or True Stress

Status
Not open for further replies.
rh142

rh142

Nuclear
Jul 24, 2007
20
Should engineering or tru stress-strain curve be input for material properties.

Thanks,
 
Replies continue below

Recommended for you

Sort by date Sort by votes
We should use true stress strain
and if Nonlinear GEom is on
Use True Stress and logarithmic strain
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

LS_SMS
  • Locked
  • Question
Zero Through-Thickness Bending Stress 1
Replies
9
Views
1K
TGS4
TGS4
W
  • Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
1K
weldtest12
W
shiraz883
  • Locked
  • Question
Nodal forces and Von-mises stress
Replies
0
Views
301
shiraz883
shiraz883
vickyiamlucky
  • Locked
  • Question
Ansys Symmetry model to full model cut boundary dispacemnt or force bc
Replies
0
Views
616
vickyiamlucky
vickyiamlucky
shiraz883
  • Locked
  • Question
Stresses increase on adding thermal boundary conditions/ thermal load
Replies
1
Views
336
SWComposites
SWComposites

Part and Inventory Search

Sponsor

Back
Top Bottom