Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Enercalc Masonry Slender Wall

Thread starter bgsmith
Start date Mar 9, 2012

Status: Not open for further replies.

Mar 9, 2012

bgsmith

Structural

I have been using the newer version of Enercalc (version 6) for a variety of designs. I noticed when using the masonry wall design module that some of the results didn't look correct. The axial stress and calculated deflections look much higher than calculated using rough hand calcs. Has anybody else experienced this?