S
sagies
Guest
Hi,
I'm totally new. I have and initial problem: I receive the following error:
"Emboss failed: only planer, cylindrical or conical faces are supported for wrapping".
I attached a link of a curved cone product that resembles mine - It's probably not a proper cone and that explains the error message, so then how do I extrude a wrap around this body (the lower part)?
thanks a lot.
I'm totally new. I have and initial problem: I receive the following error:
"Emboss failed: only planer, cylindrical or conical faces are supported for wrapping".
I attached a link of a curved cone product that resembles mine - It's probably not a proper cone and that explains the error message, so then how do I extrude a wrap around this body (the lower part)?
thanks a lot.
