Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

electrical routing ports

Status
Not open for further replies.
doublecut

doublecut

Electrical
Joined
Jun 25, 2021
Messages
1
Location
US
When electrical routing, the pre-defined port extensions still appear even when ports are not in the work part. Why do the extensions disappear when you make your work part the display-part and the spline only relies on the center point?
 
Sort by date Sort by votes
Can you illustrate this ?
What NX Version is this ?

Regards,
Tomas

Never try to teach a pig to sing. I wastes your time and it annoys the pig.:-)
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Dave W
  • Locked
  • Question Question
Electrical Routing and Deformable
Replies
1
Views
428
jerry1423
jerry1423
CAD2015
  • Locked
  • Question Question
NX Electrical Routing vs Catia Electrical Harness
Replies
0
Views
252
CAD2015
CAD2015
designnewz
  • Locked
  • Question Question
Fitting Ports in Electrical
Replies
5
Views
375
cowski
cowski
jerry1423
  • Locked
  • Question Question
Move spline points with Mechanical Routing
Replies
2
Views
525
jerry1423
jerry1423
jerry1423
  • Locked
  • Question Question
Mechanical Routing - add curves
Replies
3
Views
371
nxexplorer
nxexplorer

Part and Inventory Search

Sponsor

Back
Top