Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

*EL print

Status
Not open for further replies.

Bayram2014

Geotechnical
Joined
Jun 25, 2021
Messages
27
Location
FR
Hi ll,
I wanted to get the stresses at an ELSET and wrote:

*EL print ,elset=ELsetFront_HB,POSITION=AVERAGED AT NODES,frequency=100000
S11, S22, S12

I got a table like :
NODE FOOT- S11 S22 S12
NOTE
1 -4614. 1.2010E+06 5178.
5 -5.7100E+04 1.6403E+06 5.2975E+04
9 -1.9227E+06 -6.1784E+06 0.2785
10 -1.6184E+07 -1.0650E+07 3.1670E+05
.
.
.
218230 1.1117E+04 -1.6956E+06 4.5990E+04
218234 1.2195E+04 -2.2781E+06 8.4795E+04

My problem is that the hole mesh has only 180851 nodes and 160000 elements.
So what are the node numbers given in my .dat file ?
Regards,

 
Node number don't have to start from 1 and they don't have to be continuous. Check the numbering of nodes in that set. You can also highlight a particular node in Abaqus/Viewer so pick one of those high numbers from the .dat file and try to find it in the result mesh.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top