Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ekill command and changing the material number

Status
Not open for further replies.
jiligeo

jiligeo

Geotechnical
Joined
Feb 24, 2005
Messages
145
Location
DE
Hi, is it possible to change the material number during the analysis (to model the lining in tunnel)? I used “Ekill” for modelling the excavation in tunnel but I have problem for modelling the lining! Do you have any experience in this field?

Thanks
Jili
 
Status
Not open for further replies.

Similar threads

IJR
  • Locked
  • Question Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
1K
IJR
IJR
Ahmed_abdelgawad
  • Question Question
CDB and ‘prnsol,s’
Replies
0
Views
6K
Ahmed_abdelgawad
Ahmed_abdelgawad
W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
nashki
  • Locked
  • Question Question
UDL on the Curve of Elbow
Replies
0
Views
3K
nashki
nashki
AndrewSkocz
  • Locked
  • Question Question
Ansys - Solving an input file using command line
Replies
3
Views
1K
NRP99
NRP99

Part and Inventory Search

Sponsor

Back
Top