Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ejector Manage together in Mould Tooling Design

Status
Not open for further replies.

Sendoacf

Chemical
Joined
Jun 10, 2022
Messages
8
Location
ES
Hi,
Im working with the Mould Tooling Designer and I have a question
When I insert my Ejector pins or sleeves using the Catia V5 tool i can puth them together using sketch. After this i can split them all with in one operation using a plane or a surface. But now i want manage them together like if they were a single part, i would like to make them all a pocket for example. How could i do
 
Hi Sendoacf,

I'm also using Mold Tooling Design workbench! It has a few (many...) shortcomings, but I haven't found yet a faster way to put together the type of tooling I'm building.

About your question, what exactly do you want to do? Open the pockets for the ejectors?
That is very easy if you use the command "Distributed Drill Component", and you can do all the pockets at once.
If that's what you are looking for let me know and I can show you how to do it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top