edrawings 2006 model colour

[djw2k3]

Hi All,

When publishing an edrawing from within the SolidWorks environment (assembly) the colour of some components turn green - a bit like the "component selected" green in the edrawing.

But if I open the Solidworks assembly in edrawings itself the colours are fine.

Obviously not really a problem, but just annoying. Anyone else have this issue?

SW2006 SP3
edrawings Pro 2006

DW

 

[ctopher]

Does it do it on another PC with the same file? What video card do you have?

Chris
Systems Analyst, I.S.
SolidWorks/PDMWorks 05
AutoCAD 05
ctopher's home site (updated 06-21-05)
FAQ559-1100
FAQ559-716

 

[djw2k3]

Hi ctopher

Am a one man band so can't check on another PC.

My vid card Quadro Go 700, (Dell M60 system)

Dave

 

[ctopher]

It may be the vid card. Check the FAQ and

http://www.solidworks.com

for hardware supported.

Chris
Systems Analyst, I.S.
SolidWorks/PDMWorks 05
AutoCAD 05
ctopher's home site (updated 06-21-05)
FAQ559-1100
FAQ559-716

 

[GoWithTheFlo]

Hi,
Sorry to revive an old thread, but I have the same problem and no solutions were found here. I checked my video card drivers (like Ctopher said), and everything is fine.
I am downloading SP 4.1 now and the last version of eDrawing to see if it fixes anything, but I was wondering if anyone knew for sure how to fix this.

Thank you for your time.

 

[Mindnumb]

have the same problem, but no cure...

 

[CorBlimeyLimey]

Can you all post your system & software specs to see if there is a common factor?


Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091

 

[SBaugh]

Click on the UI and make sure it's turned off. Also if click in the Feature tree in the Edrawings that will cause everythign to turn green. Click in the graphics area.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376