Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

edit-face-face edit

Status
Not open for further replies.

mold---k

Computer
Joined
Mar 19, 2022
Messages
1
Location
KR
edit-face-face edit
nx9-support
edit face,,,,,nx10 version supported?

2010-12-01_164633_rvxpjm.png
 
[ul]
[li]Move face[/li]
[li]Replace face[/li]
[li]Delete face[/li]
[li]Resize face[/li]
[/ul]

All present and funtional in NX 11.
 
Replace Face should work the best, but if it is a dumb solid (unparametrized) then Optimize Face will work nicely.

Jerry J.
UGV5-NX1961
 
If I guess, the question is:
"where did the very-very-very old face edit commands from Unigraphics go in newer of versions of NX ?"
Somewhere along the timeline they were most probably replaced by the so called "direct modeling" toolset, you should find features which can do the same and more.


Regards,
Tomas

Never try to teach a pig to sing. I wastes your time and it annoys the pig.:-)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top