Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Eccentric Bottom Cone

Status
Not open for further replies.
clp

clp

Mechanical
Joined
Mar 3, 2004
Messages
22
Location
US
I have a small 12" OD vertical ASME vessel (100spi/fv, 100F, 316L mat'l)and I'm having problems calculating the bottom "eccentric" cone. Typically cones are concentric and I'm not sure how to account for the eccentricity (or if it even needs to be considered in such a small vessel).

Any suggestions would be greatly appreciated.
clp
 
Sort by date Sort by votes
See UG-36 esp. FIG.UG-36(e)
 
Upvote 0 Downvote
deanc
thank you - that helped.
clp
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

cak4Engg
  • Locked
  • Question Question
Cone to Weld Neck Flange Junction in ASME Sec VIII Div-1
Replies
3
Views
633
cak4Engg
cak4Engg
K.P.M.
  • Locked
  • Question Question
Eccentri shell with Cone
Replies
8
Views
372
SnTMan
SnTMan
mohammad1367
  • Locked
  • Question Question
Rectangular tank bottom to shell joint design & seismic evaluation
Replies
2
Views
156
mohammad1367
mohammad1367
timsch
  • Locked
  • Question Question
UG-36 & eccentric reducer requirements
Replies
5
Views
208
timsch
timsch
roca
  • Locked
  • Question Question
RTJ Flange Bottom Groove Radius
Replies
2
Views
274
roca
roca

Part and Inventory Search

Sponsor

Back
Top