Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Dynamic Blocks
- Thread starter civeng80
- Start date
I use them all the time in generating electrical prints and PI&D drawings. For example I now have just one control relay contact block and I have automated it for NC or NO using a visibility parameter in the dynamic block. Another example is my terminal strip dynamic block. I plunk a terminal strip down and then I can stretch or shrink it to the discrete number of terminals with proper spacing needed depending upon the number of terminals on the TB.
I don't know if LT supports them or not. Sorry.
I don't know if LT supports them or not. Sorry.
Not really. sorry.
You can use it, but not create a db.
Lothar
ADT 2004
You can use it, but not create a db.
Lothar
ADT 2004
I use them a lot but not with LT. A great time saver. We have one that for pipe flanges. It can be any size up to 36", be blind, weld-neck or slip-on and change orientation. Another one does valves. They have their place but regular blocks are better in some instances.
- Status
Similar threads
